Description
The D-Link DGE-528T is a high-performance 10/100/1000Mbps copper Gigabit PCI card for desktop PC. Installable in a PC equipped with PCI expansion slots, this card turns a desktop computer into a high-bandwidth Gigabit workstation or a server running at 2000Mbps full-duplex speed.
Benefits
High-performance Gigabit Speed:
Capable of running at full-duplex Gigabit speed, this card gives your PC 2000Mbps data transmission on your existing Cat. 5 twisted-pair network cable. As an inexpensive alternative solution to fiber-optic, the card allows you to instantly upgrade to Gigabit without requiring you to install new, expensive fiber cables. The card supports 10/100/1000Mbps network speed auto-sensing and full/half duplex auto-negotiation.VLAN to Improve Performance and Security:
The card provides on-board screening of VLANs Tagged Ethernet frames, allowing your PC to be configured with a VLAN-supported switch. Your PC can be part of a VLAN network, where domains are segmented up to enhance performance and security.
Wake-On-LAN for Power Management:
Wake-On-LAN (WOL) is an Advanced Configuration Power Interface (ACPI) function allowing a powered OFF computer to be powered ON from a remote station. This function allows the administrator to send wake-up signals to a computer. The WOL function provides a great utility for power management of the PC and allows users to initiate action at irregular times and from distant locations.
Flow Control to Minimize Packet Loss:
The card's embedded flow control and independent FIFO provide a means to protect against possible data loss during transmission on the network. When connected to a Gigabit switch supporting flow control, the card receives signals from the switch regarding buffer overrun during peak usage periods. The card then delays transmission until the switch is ready again to accept new data.
Small Form Factor, Lower Power Requirement:
Using a single chip solution, this card is very small in size and consumes very little power of your computer system.
Copper Gigabit connection for PC
10/100/1000Mbps auto-sensing speeds
2000Mbps Gigabit full duplex support
32-bit 33/66MHz clock speed PCI Bus Master operation
Built-in FIFO (8K/64K) buffer to reduce overhead of memory transfers
Supports auto MDI/MDIX and 802.3x Flow Control Supports ACPI 2.0
WOL power management and 802.1Q VLAN Tagging
PCI 2.1, 2.2 plug-and-play
Specifications
Technical Specifications
Standards IEEE 802.3 10BASE-T Ethernet
IEEE 802.3u 100BASE-TX Fast Ethernet
IEEE 802.3ab 1000BASE-T Gigabit Ethernet
ANSI/IEEE 802.3 NWay auto-negotiation
PCI local bus 2.1, 2.2 specifications
IEEE 802.3x Flow Control
IEEE 802.1Q VLAN tagging
Protocol CSMA/CD
Data Transfer Rates Ethernet: 10Mbps (half duplex) 20Mbps (full duplex)
Fast Ethernet: 100Mbps (half duplex) 200Mbps (full duplex)
Gigabit Ethernet:2000Mbps (full duplex)
Network Cables 10BASE-T: UTP Cat. 3, 4, 5 (100 m max.) EIA/TIA-586 100-ohm STP (100 m max.)
100BASE-TX, 1000BASE-T: UTP Cat. 5 (100 m max.) EIA/TIA-568 100-ohm STP (100 m max.)
Flow Control IEEE 802.3x flow control per for full duplex
Back pressure in half duplex
Full/half Duplex Full duplex only (1000Mbps)
Full/half duplex (10/100Mbps)
Diagnostic LED Report 1000/100/10Mbps
Full duplex
System Setup
IRQ Allocated by system
I/O Address Allocated by system
Operating Temperature 0° to 50° C
Storage Temperature 10° to 70° C
Operating Humidity 10% to 90% RH
Storage Humidity 5% to 90% RG
Emission FCC Class B
CE Class B
VCCI Class B
Network O.S. Support Microsoft Windows 98, NT 4.0, ME, 2000, XP
Novell NetWare Server 5.x, 6.x
Linux kernel 2.2.x, 2.4.x
Macintosh OS X
Available at The Creator Systems, Dlink Dealer in Dehradun, Uttarakhand, India / www.thecreatorsystems.com
0 comments:
Post a Comment